Lencore hub motor for people who want the best.

Elevate your  ride with our Lencore Hub Motor. Designed for both high torque AND high speed, this hub motor is a significant upgrade for any build. This motor has a rim diameter of 6 inch and is also 6 inch wide, making it compatible with onewheel XR tires like the endure from The Float life. Our recently developed axle blocks also make the motor compatible with the XR frame.

Powerful Performance

Achieve speeds of up to 60 km/h at 72 volts without field weakening, thanks to the motor’s 4000-watt output and a torque of up to 80 Nm. This power surplus ensures not just exhilarating speed but also enhanced safety and dependability. This ensures both low speed torque and high speed power. The greater efficiency also reduces battery power consumption for enhanced range.

Compatible with many platforms including the onewheel XR

This hub motor is shipped including axle blocks that fit the Lenco Wheel V4, V5, V6 and onewheel XR. Off course its also possible to design your own frame around the motor for DIY enthousiast. We are currently testing GT axle blocks and expect then ready for shipment in 2 months.

The Perfect Choice for Your Build

When it comes to enhancing your board, the Wheel Hub Motor stands largely unrivaled. It’s the most powerful and robust choice, ensuring that your build is equipped to compete with the best. Whether you’re tackling challenging trails or navigating the urban jungle, this hub motor is your guarantee of top-tier performance. It’s not just an upgrade; it’s the key to unlocking the full potential of your ride, making every journey, whether on rough terrain or city streets, a testament to the power and versatility of your build.

Shipping

We have part in at the factory so we can start assembly right after your order. Expect a lead time of 2 – 4 weeks after you placed your order.

Important info!

Power is defined as voltage * amperage. Because most people are limited to a max voltage of 84 volt, the only way to increase power is to increase the amperage. The motor is more than capable but every part in the chain must be up for the task. Make sure your wiring, connectors and VESC are all rated for the increased amperage. During testing in harsh conditions (30 degrees Celsius ambient temperature, very rough uphill trail) we found that the the little foccer V3.1 vesc will overheat in a matter of minutes. The Spintend UBOX 150a would not rise above 55 degrees, even with a rider weight exceeding 90 kg. Make sure your choose the right VESC or contact us for advice. Because of great variability in connectors and high amp demand, the motor will have 4mm pre soldered bullet connectors and a M20 metal cable gland. Hall sensor connector vary greatly in pin-out so unfortunately we cant pre crimp a JST connector for hall sensors.